1. Demonstration work must be done
Before the welding robot performs automatic welding, the operator must teach the robot's welding gun trajectory and set welding conditions.
2. The accuracy of the workpiece must be ensured
The robot has no eyes and can only repeat the same actions. The robot trajectory accuracy is ±0.1mm, and the same action is repeated with this accuracy. When the welding deviation is greater than the welding wire radius, the welding may not be good, so the accuracy of the workpiece should be kept within the welding wire radius.
3. The setting of welding conditions depends on the skill level of the teaching operator
The operator must input welding procedures, welding torch posture and angle, current, voltage, speed and other welding conditions when teaching.
The teaching operator must fully master welding knowledge and welding skills.
4. Full attention must be paid to safety
The robot is a kind of high-speed motion equipment, and it is absolutely forbidden for people to approach the robot during its automatic operation (safety guardrail must be set). Operators must receive special education in labor safety, otherwise they are not allowed to operate.